The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: help! AW10 going pop



Using the formula  "  Power = Volts * Amps  " and transposing
gets " Amps =
Power / Volts " then with the current nominal supply voltage of 230
volts
and the imeersion heater rated at 3000watts then  you are looking at a
minimum 13Amps hence the reason they are usually fed from their own 15A
circuit from the fuse box.

Was an electrician in past life (JIB approved as well)...

Regards
Paul


----- Original Message -----
From: "Roger" <roger@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Tuesday, February 26, 2002 4:14 PM
Subject: RE: [ukha_d] help! AW10 going pop


> RTFM (Read The F****** Manual ----- or could be Ring The Fire-Brigade
Mate!)
>
> On LetsAutomate the ratings re given as:
> 10A Resistive (AC assumed)
> 3A Motor
> Incandescent 2000W
>
> As an immersion heater is slightly inductive (anyone ever measure
one?)
the
> current rating will be a bit less than 10A
>
>
>
> Roger Shingler
>
>
> -----Original Message-----
> From: kinchyuk [mailto:kinchyuk@xxxxxxx]
> Sent: 26 February 2002 15:52
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] help! AW10 going pop
>
>
>
> Just wired up an AW10 to an 3kW immersion heater, when I tap the
> switch there's a loud pop, a blue flash, and not a lot happens - the
> load remains switched on whatever. The red light on the front doesn't
> light at all.
>
> Taken everything apart, wiring is fine. Any suggestions? Is 3kW a bit
> much for an AW10?
>
> Alex
>
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.