Napco GEM-P9600 Strange Behavior After Power Outage

[Grant P <wallywaldoworkwear@xxxxxxxxx>]

Lost power for extended period of time.  Battery went dead.  I have an Expansion Zone Module (EZM) and three partitions configured on the 9600.

After power was restored, the following things are occurring:
1-The EZM red LED is solid and the module is beeping every 34 seconds.
2-The keypad for the primary partition says **Zones Faulted** and it then proceeds to display each of the following numbers, one at a time, of: 01-, 02-, 03-,....08-.  It then repeats this continuously.
3-The keypads for the other two partitions are continuously displaying '02-Out of System' and '03-Out of System' respectively.

Any ideas what has happened and how to fix it?