Re: Schema for FirM

["Frank Mc Alinden" <frankmc@xxxxxxxxxxxxxxxx>]

Hi John

> Happy new year!

And the same  to you !

> Looks OK, though should be current=1 instead of zone=1

I just realised after i posted that it really should be as you mentioned...


> One idea though:
>
> Why not use type=zone, rather than firm? e.g.

Ok ...no problem ....Looks good will go with your suggestions

Thanks a lot

Frank


----- Original Message -----
From: "John B" <home-automation@xxxxxxx>
To: <ukha_xpl@xxxxxxx>
Sent: Sunday, January 01, 2006 9:04 PM
Subject: RE: [ukha_xpl] Schema for FirM


> Hi Frank,
>
> Happy new year!
>
>> Im thinking of using something like this instead of my
>> prvious mentioned commands...mentioned below ......
>>
>> For commanding to set up txing to zone 1 example
>>
>> device=transmitter
>> type=firm
>> zone=1
>
> Looks OK, though should be current=1 instead of zone=1
>
>>
>> For Requesting the Receiving Zone from FirM
>>
>> device=receiver
>> type=firm
>> current=request
>
> Looks fine.
>
> One idea though:
>
> Why not use type=zone, rather than firm? e.g.
>
> Xpl-cmnd
> {
> ...
> }
> Control.basic
> {
> Device=transmitter
> Type=zone
> Current=1
> }
>
> This will set the Tx zone to 1.
>
> And to get the last zone:
>
> Xpl-cmnd
> {
> ...
> }
> Control.basic
> {
> device=receiver
> type=zone
> current=request
> }
>
> The reply would be something like:
>
> Xpl-stat
> {
> ...
> }
> sensor.basic
> {
> device=receiver
> type=zone
> current=2
> }
>
> This indicates the last signal came from zone 2.
>
> Regards,
>
> John
>
>
> xPL Links: http://www.xplproject.org.uk http://www.xplhal.com
> http://www.xpl.myby.co.uk
> To Post a Message: ukha_xpl@xxxxxxx
> To Subscribe:  ukha_xpl-subscribe@xxxxxxx
> To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx
> Yahoo! Groups Links
>
>
>
>
>
>



xPL Links: http://www.xplproject.org.uk http://www.xplhal.com http://www.xpl.myby.co.uk
To Post a Message: ukha_xpl@xxxxxxx
To Subscribe:  ukha_xpl-subscribe@xxxxxxx
To Unsubscribe:  ukha_xpl-unsubscribe@xxxxxxx