> What I need is for the values of these parameters that have
> been stored in xPLHal to be sent to my app BEFORE
> xpl_configured event fires. Or have I got the wrong end of the stick?
Wrong end of the stick ;-)
The configured event is fired when a config.response arrives from xplhal
It is this event (or the idividual item events if preferred) that should be
used to configure the device (though you can set default values in the form
load)
The xpl ocx will not pass messages to the app (normally) anyway until the
configured event fires.
Regards
Tony
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.