Re: Re: X10 TM13 behaviour

["Mal Lansell" <mlansell@xxxxxxxxxxxxxx>]

I use xPL.

Everything received via RF is sent down the powerline.  I can switch the
built in appliance module on and off using the remote, but nothing happens
if I send that command via the powerline (from the PC).

I thought I'd read somewhere that the appliance module in the TM13 only
responded to RF commands - but maybe I was wrong and the unit is duff.

Mal




----- Original Message -----
From: "sholaouk" <internet_security_consultant@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Thursday, December 02, 2004 3:37 PM
Subject: [ukha_d] Re: X10 TM13 behaviour


>
>
>
> What are you using to send the X10 controls?
>
> I use misterhouse, and I can control my TM13 using either the RF
> Remote or Misterhouse.
>
> I can see the RF commands on the powerline, and when I use
> misterhouse to control the TM13, similar x10 commands are sent over
> the powerline.
>
> If you are able to monitor the commands on the powerline, and they
> are the same, then the TM13 could be broken, otherwise you might be
> issuing the wrong command, hence the lack of response.
>
> Shola
> --- In ukha_d@xxxxxxx, "Mal Lansell" <mlansell@f...>
wrote:
> > Hmmm.  Looks like it's buggered then :-(
> >
> >
> > ----- Original Message -----
> > From: "K. C. Li" <li@l...>
> > To: <ukha_d@xxxxxxx>
>
>
>
>
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>