The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Reliable IR over Cat5


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Reliable IR over Cat5
  • From: "Dan Khan" <dan@xxxxxxx>
  • Date: Tue, 19 Mar 2002 12:20:27 -0000
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Thanks for the help,

I assume you cut off the receiver end and replaced with an RJ45 plug?
Do you have any problems of line interference?

So I would also need to make up a RJ45 to 3.5mm jack patch cable to
connect to the amp/patch panel at node 0.

-Dan


-----Original Message-----
From: Alancc [mailto:alan.cc@xxxxxxx]=20
Sent: 19 March 2002 12:03
To: ukha_d@xxxxxxx
Subject: Re: [ukha_d] Reliable IR over Cat5

If you want a cheaper alternative try the kit from Keen, I have a
receiver
feeding off to two transmitters via a distribution amp, these work a
treat
over 20 mtrs of CAT5. CPC sell the kit of amp, two TX, PSU and RX for
about
=A340.00 +VAT.
<snip>




Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.