[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Conversion of appliance modules to DIN rail
- To: ukha_d@xxxxxxx
- Subject: Conversion of appliance modules to DIN rail
- From: Julian Driver <julian@xxxxxxx>
- Date: Mon, 7 May 2001 17:16:17 +0100
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
I have bought some appliance modules cheap from my local Homebase. Some
need to go into DIN housings and so I have removed the plug and socket
bit to end up with a neat unit 50*70*30 mm with three wirs from the
bottom. These can be neatly fitted into a connector block.
My question is if anybody has seen some sort of a clip to fit to
standard DIN rail. If there is such a thing I could then neatly fasten
these units in place, the alternative being tie-wraps or gaffer tape.
NOT a pretty sight.
--
Julian Driver
Home |
Main Index |
Thread Index
|