The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Bl**dy OnDigital...


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Bl**dy OnDigital...
  • From: "James Hoye" <james.hoye@xxxxxxx>
  • Date: Tue, 21 Aug 2001 11:31:20 +0100
  • Delivered-to: rich@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

> I've done all of this. Analogue channels are better (back to as
> good as they
> were before they had to struggle through the OD box) and digital
> channels have
> loads of oomph, but still I get breakup at times.

If you fire one of those peizo gas igniters in the vicinity of an analogue
set, you get loads of interference across the screen.  I suppose the
electrical interference has the same effect on the digital signal since
this
is just an RF signal.  Error correction will do its best to a point, but if
the bitstream is too corrupted then you're going to get break up.  Same
goes
for motorbikes and cars without supressors, light switches, in fact
anything
that generates a spark and causes an electromagnetic disturbance....

James H


For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/




Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.