It powers up, can scan the programming barcodes from the zygo website
but as soon as I scan the test barcode, the scanner locks up and
doesn't respond.
If I disconnect the power and reconnect the scanner comes back to
life until I scan something (the program codes are still fine.)
If I disconnect the serial cable then reset the scanner It will
acknowledge the scans by beeping.
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.