>
Do you have any wiring daiagrams for the Buffalo and
Xantech
> rx
> units.....Do they have any electronic in side other than an ir
receiver???
> For instance are the connections as follows
I should have some diagrams at home, if I can I'll scan them and send
them later. However the Xantech ones are the same as the pdfs @ http://www.xantech.com/ which should
be a lot better than my scans. To
me the Buffalo tubes look to be the same as the Xantech version and
they
certainly work as the Xantach on the Xantech amp.
> +12v
> signal
> gnd
> What type of connector is used???
Yes, that is exactly how its done on all the emitters and they came
with
just bare wires, no connector at all.
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.