It is someone who succeed to modify a X10 lamp module (LM12) in order
to
support 1000W (not only 300 as the basic one)?
It is enough to change the triac (now a BTA10/400C(10A/400V) with an
BT139
(12A/800V) or the driver must be modified too?
More... I want to connect a local switch (touch control) to be able to
dim
the light locally too. Where can I found the schematic for the LM12
module?
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.