What does switch mode mean?
Another thing to mention is that my logfile shows lots of commands received
like the following 'A777777777777 on, O33333333333 off. Obviously
erroneous.
-----Original Message-----
From: Phil Harris [mailto:phil@xxxxxxx]
Sent: 30 March 2004 12:43
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] LCD Screen interfering with X10
> I use a cheap GNR 15 inch LCD monitor with about 6 appliance
> modules in the immediate vicinity without problems. I can
> operate these from both HV and local control via timers.
I think the problem - as we usually find - comes down to switch mode PSUs.
They're absolute buggers for banging out *HUGE* amounts of mains noise but
an X10 mains filter *SHOULD* cure it - if it doesn't then maybe there's a
fault with the filter?
Phil
UK Home Automation Meet 2004 - BOOK NOW!
http://www.ukha2004.comhttp://www.automatedhome.co.uk
Member Offers - http://www.freeranger.co.uk/ukha
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.